Scirocco Register

Got a repalcment door for the rocco, and it had a decal along the side, removed the decal no probs but you can still see there it was ie its raised in areas, tried t-cutting it but no good, anmy ideas? was thinking about a claybar? or as a last resort wet and dry?





Cheers Heath

Is it not glue dude, left from the decal?

If its not, looking like the best option would be to get it machined mate

Alex

It doesnt appear to be glue, its been heavily t-cut!!!!!!

was going to clay bar it, however i havent done this before!!!!! any pointers?

Not sure a clay bar will do the job, but well worth a shot. Just use plenty of water/quick detailer. Read my guide dude, covers most aspects of using one

Alex

I used autoglym tar remover to get rid of the marks from my decals. I wish I hadnt taken them off my as I dont know where to get replacments! Maybe they were a factory option?

What about some good old fashioned rubbing compound? Then again it might be too severe.

Pretty sure clay bar won't touch it. We have the same on the boot of ours, small dealer name or something die cut. Did the claybar and 3 step maguiars (by hand, no machine)... Great shine, but letters still there.

What about going over it with a toffee wheel?