vdo oil temp sender

Gilb666 · Post by **Gilb666** » Fri Jan 07, 2011 8:31 am

Hi all

Just picked up a set of VDO gauges, and seperatly a set of senders

What do i need to connect to the top of the temp sender? i've not seen a connection like this before

a pic of something similar - http://shop1.actinicexpress.co.uk/shops ... arge-1.JPG

anyone know what i need, or better yet where i can get it?

Cheers

Marcus

Post by **PeteGLi** » Fri Jan 07, 2011 10:02 am

Standard female blade connector.

Have a look at your current water and oil temperature senders - the wires connecting to them will show what you need.

Gilb666 · Post by **Gilb666** » Fri Jan 07, 2011 10:58 am

Its not the same as the water temp sender (presuming i've got the right one, right hand side of the cylinder head?) as that has a standard spade connector

the pressure sender also has the same normal spade connectors

The one on the oil temp sender is more like a half sized drawing pin / mushroom shaped thingy

Birdy · Post by **Birdy** » Fri Jan 07, 2011 12:02 pm

A spade connector will still be fine, slide it over the pin and it'll work

Jay4424 · Post by **Jay4424** » Fri Jan 07, 2011 12:37 pm

Birdy wrote:A spade connector will still be fine, slide it over the pin and it'll work

more than fine, it is what its suppost to be, as previouse posts.

..solder it if your really that bothered!

Gilb666 · Post by **Gilb666** » Fri Jan 07, 2011 1:23 pm

was trying to figure out how to make a spade conenctor fit it, i've only just through it will fit over the other way lol

Cheers guys!

Scirocco Register

Scirocco Register

vdo oil temp sender

vdo oil temp sender

Re: vdo oil temp sender

Re: vdo oil temp sender

Re: vdo oil temp sender

Re: vdo oil temp sender

Re: vdo oil temp sender