Bumper strip

Whitescala89 · Post by **Whitescala89** » Tue May 04, 2010 9:27 pm

Is it possible to remove the bumper strips for spraying? Or will i just need a lot of patience and some masking tape?

Post by **GTXTRA** » Tue May 04, 2010 10:05 pm

just pops out, wrap a screw driver in a cloth and gently ease out one of the ends to start it off.

Funky Diver · Post by **Funky Diver** » Tue May 04, 2010 10:46 pm

GTXTRA wrote:just pops out, wrap a screw driver in a cloth and gently ease out one of the ends to start it off.

What about the bumper strip... mwaaaaaaaaahahahahahahahaaaaa

I'll get my coat...

HotSoutheastWind · Post by **HotSoutheastWind** » Sat May 15, 2010 3:38 pm

Funky Diver wrote:
GTXTRA wrote:just pops out, wrap a screw driver in a cloth and gently ease out one of the ends to start it off.
What about the bumper strip... mwaaaaaaaaahahahahahahahaaaaa

I'll get my coat...

Haha this made me chuckle

lenny125 · Post by **lenny125** » Sat May 15, 2010 7:37 pm

It would be easier to take the bumper strips out and spray them but the only problem will be is when putting them back in. I was going to do the same so I bought some new ones and took them down to a bodyshop and they said when putting the strips back in it will crack the paint on them. So I have to say you will need to get the masking tape out, it took me about 40 mins to do both bumpers to mask them up.

Whitescala89 · Post by **Whitescala89** » Mon May 17, 2010 7:39 pm

I think i will mask them as i looked at an old bumper i had in my shed and they dont seem to come out very easily.

Scirocco Register

Scirocco Register

Bumper strip

Bumper strip

Re: Bumper strip

Re: Bumper strip

Re: Bumper strip

Re: Bumper strip

Re: Bumper strip