Had the privaledge of giving Chris and Eve a lift from their digs in Wolverhampton back to the campsite so they could have a bevvy or three in Black Shuck, thoroughly nice couple and such sad news of his passing. Rip young man.

^^^ What James said! Couldnt keep the guy on track what with a sudden upturn of business in his daily job and less time to devote to it, shame as Daves kit would have been way superior to the heritage one in quality. I ordered one from them a while back and although it did the job (only on the ...

james butler wrote:does your diff housing where the seal goes have the sticky out green thing sort of around the seal housing on one side?

it does mate

I seem to keep coming up with different sizes and part numbers for this and as I need to replace mine. could do with getting the right part, anyone help out here?

020 gearbox, 1.8 1990 carb gt2

Can confirm this does work!

Phil i may have asked this question before but "Where are you?" Another rocco owner from Cannock on here, weve got to meet up!

As far as I know, Joost (Blueshark) can do the filler necks, its just the end piece thats a problem (that the cap goes onto) but im led to believe that if you lop yours off and send he'll attach it.

Could be wrong about all or some of the above but Blueshark will put you right im sure

Dont EVER fit stainless front anti roll bar clamps! One wrong move and they will snap, shoot upwards and rip right through your cv boots, just like the ones that were fitted to mine did!

Best one I have!

im hoping too as i cant actually get to Cosford (again!) but someones got to setup the essential at the site, has to be someone from my work and ill be damned if anyone else is going to do it other than me!
Black Shuck will obviously be in attendance also, aint doing it in one of our crap vans thats ...

right i think i had best post what happened the other day when James popped over!

Firstly he detached the vapour separator and connected a y piece which seemed to solve the dripping fuel issue but not the actual problem, turned out, right at the end to be the mix screw had caught on a bit of swarf ...

Tis i with above problem so thought id pop in and give some background to the problem.
Symptoms, best to start where it all began! Overheating on the way to James's, rad fan failure which led to thermostat failure, leading to water pump failure leading to inlet gasket cookery! (Domino effect over a ...

Just a cautionary warning to anyone tempted to fit stainless outer clamps, mine was fitted with them, both snapped, shot up and tore thru both cv boots! Mark Carter over at classic vw sent two genuine vw ones to replace, much better as not being stainless, they have at least some "give"
(Boots ...

Guys id love to just say "Yep, got a load all made up, ready to go" sadly however we hit a few snags, biggest one was Dave the engineer must have misinterpreted what I said regarding the fog lights (or I said it wrong), basically we are short of a connector to plug into those, his supplier doesnt ...

Decided against it, just cant part with it!