Page 1 of 1

kent cam

Posted: Wed Mar 09, 2011 10:45 pm
by T0M
my new cam arrived today :) however have just noticed that it does not have a notch on the end that the pulley slots onto like the standard one does.
is this a problem? or is the notch just so you put it on at the right angle for the timing marks of the standard cam?

cheers, Tom

Re: kent cam

Posted: Wed Mar 09, 2011 10:53 pm
by T0M
i withdraw my stupid question :blush: just realised the notch comes off the old cam and goes in zee new one...

Re: kent cam

Posted: Wed Mar 09, 2011 11:05 pm
by Funky Diver
the notch is called a key ;)

Re: kent cam

Posted: Thu Mar 10, 2011 6:56 pm
by steve
A woodruff key.

It's a crucial bit of metal, and well worth a few pennies from the stealers if you're in any doubt about it's condition and future prospects.