Page 1 of 1
Rear washer hole size
Posted: Wed May 02, 2018 10:21 am
by Jack92
Hey guys,
Does anyone know the size of the hole that the rear washer jet fits into?
I need to get it filled at some point but for the mean time I’m after a grommet. But being I’m in a different country I can’t measure it.
Thanks in advanced!
Re: Rear washer hole size
Posted: Wed May 02, 2018 11:02 am
by unknownmale
I welded mine up. From memory there are two holes. There smaller of the two is a bit too small for a grommet I believe. Best of just leaving the washer jet in there until you're reading to fill it.
Re: Rear washer hole size
Posted: Wed May 02, 2018 11:02 am
by unknownmale
If not, buy one of those multipacks of grommets on eBay, might be able to find something for the smaller hole.
Re: Rear washer hole size
Posted: Wed May 02, 2018 11:04 am
by Jack92
Yeah I did think that but well I already took it out and lost it haha. I have a doner car as of recently so might move it over from there.
Hoping it’s not filled up with water being that it’s raining at home and I can’t do a lot about it from where I am
Sent from my iPhone using Tapatalk
Re: Rear washer hole size
Posted: Wed May 02, 2018 10:19 pm
by essextom
I’ve got some clear plastic discs I’m getting sorted to bond in.
Re: Rear washer hole size
Posted: Wed May 02, 2018 10:19 pm
by essextom
Ignore that I didn’t read properly, mines for the glass
Re: Rear washer hole size
Posted: Thu May 03, 2018 7:30 am
by Jack92
essextom wrote:Ignore that I didn’t read properly, mines for the glass
Haha no worries thanks anyway bud
Jack
South East
www.motorsportdiscounts.co.uk
Seat Leon 1.8T 20V - Track Car
VW Scirocco Scala 1.8 Inj - Toy
Ford Transit 2.0 - Work Horse