Sunroof "water drain plate" (?) - How to attach?
Posted: Thu Aug 03, 2017 11:27 pm
Got my broken sunroof sorted to a certain extent, it was sticking up on one corner when closed and didn't work. Turned out one of the cables had jumped out of it's groove in the front guide bay. When putting it back together, I've noticed the water drain plate is not attached - the full width panel that goes at the back of the roof with the tilt hinges attached to it. It was actually sitting right at the back of the sunroof cutaway in the roof, and I had to fish it out with a long piece of wire. I don't understand about this bit. I've worked out the the little spring clip goes underneath the rail, and there's a plastic piece with a groove which I assume clips on to the rails, but how to I get this bit back on the rails in the first place? Mine was actually just sitting loose on top of the rails at the back of the sunroof cavity. Probably been like that since I bought the car.
Edit - looking at the Haynes very carefully. it looks like I have to dismantle everything again, and actually take the front part of the guide rails off, is this right? .
Edit - looking at the Haynes very carefully. it looks like I have to dismantle everything again, and actually take the front part of the guide rails off, is this right? .