Page 1 of 1
Removing loom from fuse box
Posted: Tue Jul 21, 2009 7:06 pm
by MrP
I'm currentyl doing an engine conversion and wan't to tidy the bay up which involves a lot of cleaning and spraying.. I have the engine loom in one section now but need to remove it from behind the firewall. I assume it unplugs from the fuse box. Is there just 2 big plugs or is it a case of pulling every last little wire out?
Thanks.
Re: Removing loom from fuse box
Posted: Wed Jul 22, 2009 7:05 pm
by scalainj
There is about 6 large multi plugs in the back of the fuse box and another 5 or 6 individual wires - its really easy - takes minutes
Re: Removing loom from fuse box
Posted: Wed Jul 22, 2009 10:24 pm
by Rusty dan
make sure you mark where the single connectors go as I have found it difficult not being able to remember what goes where after 18 months lol.
Of course if you are talented then you have no worries lol
Re: Removing loom from fuse box
Posted: Thu Jul 23, 2009 12:13 pm
by MrP
Rusty dan wrote:make sure you mark where the single connectors go as I have found it difficult not being able to remember what goes where after 18 months lol.
Of course if you are talented then you have no worries lol
Thats'm my only worry!