Page 1 of 1
Master Cylinder Ports
Posted: Fri Jun 21, 2013 5:20 pm
by Risocco
guys, my replacement master cylinder has 6 ports, I only need 4.
How do I block them off? OK to thread a bolt in them?
Any advice greatly appreciated
Re: Master Cylinder Ports
Posted: Fri Jun 21, 2013 6:54 pm
by Nate
My mk2 had similar. The "spares" were blanked off with mk1 brake light switches.
or just use it as an excuse to fit some nice 4 pot calipers up front, with 2 feeds to each
Re: Master Cylinder Ports
Posted: Sat Jun 22, 2013 5:22 pm
by mark1gls
Mk1 servo with brake light switches.
Re: Master Cylinder Ports
Posted: Sat Jun 22, 2013 7:03 pm
by Risocco
Cheers, bolts seem to have done the trick for now as the brakes have bled successfully for the first time in 2 years.
