Scirocco Register

Tidy bit of wrapping there.

mark1gls wrote:Tidy bit of wrapping there.

thanks, scrappy gave me a hand with the rear pipe and can confirm that this stuff itches

happy with the down pipe but it may be in vain, my abf is kjet but has an ecu so may need a lambda i can use a rocco 16v ecu too but need to look into if they use one. hopefully its only needed as part of the digi setup

still to do the top of the manofold and see how it sits on the uj

Black wrap. Very nice. I did mine in white and I am now wondering why!

i did look at gold and red wrap but i know for a fact my greasy hands will be all over it and ruin the look so black it is

BlackGTX wrote:

mark1gls wrote:Tidy bit of wrapping there.

thanks, scrappy gave me a hand with the rear pipe and can confirm that this stuff itches

happy with the down pipe but it may be in vain, my abf is kjet but has an ecu so may need a lambda i can use a rocco 16v ecu too but need to look into if they use one. hopefully its only needed as part of the digi setup

still to do the top of the manofold and see how it sits on the uj

yes inddedy, very very itchy... so much so, i binned the jumper i was wearing. thanks kieran

some more wrapping,



made space for the lambda sensor, working round it was quite complicated




wrapped the upper part to but photobucket is in no hurry for it to show in my gallery

cleaned the brake rez using gunk engine degreaser

swapped the braken res over and fitted the wrapped 421,

as expected it touches the wrapped uj but 2 layers of wrap should do it

also got some scirocco 16v injector lines, look brand new although they dont fit the dx injectors. they slide right over the top of the dx injector without having to thread and the internal thread is fewer and wider spaced, 5 rather than 8

kieran, im sure i have a set of injector lines . both styles in the garage. want me to bring them over monday ? message me pal. heat wrap round the uj boot and exhaust should be good enough. i dont have any issues

scrappy1382 wrote:kieran, im sure i have a set of injector lines . both styles in the garage. want me to bring them over monday ? message me pal. heat wrap round the uj boot and exhaust should be good enough. i dont have any issues

im gonna get some new injectors, found a seller doing them for around 35 a go

ive got dx and abf lines but neither is long enough for all 4 lines as 2 have to bend round the back of the metering head. ill post a pic soon and itll make more sense

Ok

Sent from my Moto G Play using Tapatalk

small progress

bought some 16v injectors


finished the water pipes and fuel lines so just vaccume pipework to complete the induction

Keep it up bud.

Sent from my Moto G Play using Tapatalk

it all fits together

more progress,

tapped the abf throttle body to take the 16v cable holder, never tapped a hole before so took it slow and steady and worked opposite corners






gave me an interesting problem as all 16v roccos are lhd so the cable doesnt fit neither does uk 16v cables so took advice on a mk2 golf 1.3 cable