how to replace rear anti roll bar clamp help please

traindriver69 · Post by **traindriver69** » Fri Dec 09, 2011 2:06 pm

Hi all
I am trying to put a new rear anti roll bar clamp on my mk2 rocco as the old one was missing,the problem i am having is how is the best way to clamp the clamp tight enough so that i can place the clip over the end.
i have tried a few different ways of clamping it but with no luck.
any help please

Post by **Mr Funk** » Fri Dec 09, 2011 8:23 pm

The big oval one?

An utter c*** of a job, by far the worst I've attempted. First off remove the rear beam, it'll be ten time easier as you can use a vice. Don't use a cheap one though, as my build thread shows it'll Borrick anything that isn't up to it

Old Mac Rocco · Post by **Old Mac Rocco** » Fri Dec 09, 2011 8:26 pm

Is this any help.
http://sciroccoregisterforum.co.uk/carf ... amp#p55440

Or this.

http://sciroccoregisterforum.co.uk/carf ... amp#p67793

Good Luck.

traindriver69 · Post by **traindriver69** » Sat Dec 10, 2011 11:13 am

thanks for the replys dont fancy trying to drop the rear beam got to try and find something i can use while it is on the car.

Post by **Mr Funk** » Sat Dec 10, 2011 4:24 pm

Removing the beam is easier but not essential. Just try and get the car as high as safely possible and use a vice. Do it nice and slowly and you should be fine.
Good luck, you'll need it

Scirocco Register

Scirocco Register

how to replace rear anti roll bar clamp help please

how to replace rear anti roll bar clamp help please

Re: how to replace rear anti roll bar clamp help please

Re: how to replace rear anti roll bar clamp help please

Re: how to replace rear anti roll bar clamp help please

Re: how to replace rear anti roll bar clamp help please