not much has happened of late, a trip down to knuckledusters yeilded a bonnet cable so i dont have to reach through the headlight aperture to open the bonnet now and i can put the headlight in.
ive also ordered a load of silicone hosing so hopefully can finish the cooling system.
annoyingly ive managed to loose the thermostat housing elbow i bought a few weeks ago
i need to tidy up inside and fit in the dash board and door cards but do you think i can find where i put all the screws
just as well i suppose as i need to fit a waterproof membrane to the inside to make sure it stays water tight.
is there a good way to wrap up the wiring loom to tidy it up? ive been looking at loom tape but wondered if theres something better and maybe heatproof?
i must remember to fill the gearbox with oil too
then it will be ready for mot test hopefully if all the lights still work.