Hi

Cheers for sending on the pics.
Can see how the loom is routed.

Appreciate you taking time for this
Must source some of the cable ties to dress in the loom,
These fit into the studs on the body,

Again Thanks for this
David

Hi

The car is a 1986 1.6 Carb.
I have the routing sorted down as far as the passenger headlight.
How it is routed across the front panel is where I am caught, Not sure if it clips under the slam panel. or runs along the bottom of the crossmember.

Thanks
David

Hi Is there a way of checking the rear brake proportioning valves? I am fitting a new master cylinder and the valves on the old cylinder have been sitting in a box for a long time. Also is there any way of checking to see if the servo is still ok. Access to this is easy while the engiem is out ...

Hi

I am reassembling the engine bay of my 1.6 Scirocco.
Would anyone know where I can get the ties used to secure the loom to the body.

I am also looking for photos of where the loom is routed in the engine bay especially inside the front panel.
Car has been apart for a long time :)

Thanks
David

Hi Just thought I would mention my Project. I started this in 2013 when I had to remove the engine, Had the engine rebuilt, Rear axle blasted and painted rear arches done, I was collecting parts everywhere I could find them, However due to work and few other things I lost interest in the car until ...

Hi I am re-assembling my Scirooco after a full body and engine bay re-spray. The headlight adjusters disintegrated when I was removing the headlights. I have got new adjusters for the inner and outer lamps. Does anyone now what position the fixed adjuster goes on the inner and outer lamps? Also does ...