Problem resolved. Accidentally kocked the ignition module and disconnected it when I was reaching under the gutter to remove the coil pack

Cheers! Would I need 4 or just the top 2? None, because they are for the outer lights and not the inner ones, otherwise I could have sent them with the lamps. Joost Not a prob Joost! :-) I have the m6 bolts and nuts but haven't a clue how to fit them without the units wobbling. Any tutorials or a l...

Cheers! Would I need 4 or just the top 2?

Hi all, I'm needing advice as how to fit the inner lights onto the front light brackets. @Blueshark suggested m6 bolts with locking nuts but the holes seem too large and it is difficult to stop them wobbling. Is there specific way to fit them this method or are there any other ways to fit them? Any ...

Coil pack



Dizzy cap with leads numbered to each spark


New rotor arm

The new coil pack hasn't been bolted in yet but all wires are where the should be. Ill upload a couple pics shortly.

Just tested coil number 1 and no spark from it at all. Had the ht lead connected to it and held it on the rocker cover then on the carb brackets while the engine was cranking.

Also a dark grey mk2 in Montrose a while back during mofest, gave you a thumbs as you passed but as always I never seem to be in my scirocco when I see others

Red mk2 in Dollar 2 weeks ago, it was dark and it looked to have roof bars on it. It definitely had L plates on it !

Problem resolved, never noticed the raised metal to fit the long wire from the cover ( I had been putting the male bulb wire into the plastic female bit lol)

Delete thread if necessary

The rear cover with the two female connections



The bulb with the single male connection

Wondering how to fit the h3 bulbs to the inner light covers. The bulbs only have 1 male output but the covers have 2 female. Am I missing something here at all? (The car had a single light conversion when I bought it so I've never even removed them lol)

Thanks

Chris

http://forum.sciroccoregister.co.uk/vie ... 31#p146031

Some more useful info on the situation can be found on here.

All leads are now in the correct plugs but still no luck starting. Fuel is getting to the carb but it just doesn't fire up at all. Any suggestions would be greatly appreciated.

Nothing was changed to the carb when I had it off. Fuel is getting to the carb but it's just not firing up. I've replaced the rotor arm, dizzy cap, coil pack, spark plugs and ht leads. The spark plugs were fitted before I took the carb off so I know that they are fine. Just stumped as to why it won'...